- Artikel-Nr.: RC-294
- inkl. OSD auf dem Flight Controller
- Cleanflight & Baseflight Software unterstützung (wird mit Baseflight ausgeliefert)
- leichtere optimierte Verkabelung
- dünner und leichteres Design für noch mehr Gewichtseinsparung
- saubere Verarbeitung mit hochwertigen Komponenten
- 32-bit ARM Micro Processor läuft mit 3.3V / 72MHZ
- Blackbox ready mit 2MB Speicher
- wichtigen Sensoren für ein besseres Flugverhalten sind verbaut (Gyrosensor, Kompasssensor)
- Flug Modie: Manual mode, Angle mode, Horizon mode, heading hold mode, head-free mode, Altitude hold mode (wird nur von dieser Advanced Version unterstützt)
- unterstützte Multicopter Modelle: Quadrocopter, Tricopter, Hexacopter
- unterstützte Empfänger: Standard, CPPM (PPM SUM)
- Batterie Spannungsüberwachung und Alarm bei zu niedriger Spannung.
- Micro-USB für Firmware aktualisierung und Parameter Einstellungen
- Parameter können mit Baseflight-Configuration oder Cleanflight-Configurator eingestellt werden
- GPS-Position Funktion halten und Automatische-Zurückfliegen Funktion ist mit dem optional erhältlichen GPS-Modul möglich
- Abmessung: 35mm x 35 mm x 5 mm
- Gewicht: 4.5g (ohne Kabel)
Die Skyline32 Flight Controller sind kompatibel zu Naze32 Firmware (Baseflight und Cleanflight).
Weitere Informationen finden sie unter
Baseflight https://github.com/multiwii/baseflight
Cleanflight https://github.com/cleanflight/cleanflight
Lieferumfang:
- 1x EMAX Skyline32 Flight Controller OSD Acro
- 2x RC breakout Kabel
- 1x vBat Kabel
- 1x Buzzer Kabel
- 2x UART Kabel
- 4x Nylon Schrauben/Mutter Standoffs
- 1x Header Pin Assortment (Straight and 90 Degree)
Skyline 32 Flight Controller + on board OSD to simplify your FPV build. No need for unreliable external OSD modules anymore. With a simple flick of a switch, the OSD can easily and quickly be turned ON or OFF. The OSD is integrated into the Flight Controller so setting up is simple.
Connect an fpv camera and Video Tx directly to the Skyline 32 + OSD board. With MW_OSD pre installed on the Skyline32+OSD, the pilot can change PID on the spot through OSD without having to connect to a computer. Simply use the transmitter’s stick commands and follow the OSD menu. Supports PPM signal via Channel 1 in RC_IN port (UART2), and supports SBUS signal via Channel 4 in RC_IN port (UART2).